LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 2005 >> TSX Automatic >> Repair and Diagnosis >> Drivelines & Axles >> Wheel Hubs >> Driveline/Axle >> Intermediate Shaft Installation

Intermediate Shaft Installation

  1. Install the new set ring.
    Fig 1: Identifying Set Ring
    G05491779Courtesy of AMERICAN HONDA MOTOR CO., INC.
  2. Clean the areas where the intermediate shaft contacts the differential thoroughly with solvent or brake cleaner, and dry with compressed air.
    NOTE: Do not wash the rubber parts with solvent.
  3. Insert the intermediate shaft assembly (A) into the differential until the set ring locks in the groove.
    NOTE: Insert the intermediate shaft horizontally to prevent damaging the differential oil seal (B).
    Fig 2: Identifying Intermediate Shaft And Differential Oil Seal
    G05491780Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. Install the flange bolt (A) and two dowel bolts (B). B
    Fig 3: Flange Bolt And Dowel Bolts With Torque Specifications
    G05491781Courtesy of AMERICAN HONDA MOTOR CO., INC.
  5. Install the right driveshaft (see DRIVESHAFT INSTALLATION  ).
  6. Refill the transmission with the recommended transmission fluid:
  7. Test-drive the vehicle.
scientia non olet · About LEMON Manuals