LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 2005 >> TSX Automatic >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Conventional Brake Components >> Rear Brake Disc Replacement

Rear Brake Disc Replacement

NOTE: Keep any grease off the brake disc and brake pads.
  1. Raise the rear of the vehicle, and support it with safety stands in the proper locations (see LIFT AND SUPPORT POINTS ).
  2. Remove the rear wheel.
  3. Remove the brake hose bracket mounting bolt (A).
    Fig 1: Brake Hose Bracket And Brake Caliper Bracket Mounting Bolts With Torque Specifications
    G05492121Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. Remove the brake caliper bracket mounting bolts (B), then remove the caliper assembly (C) from the knuckle. To prevent damage to the caliper assembly or brake hose, use a short piece of wire to hang the caliper assembly from the undercarriage. Do not twist the brake hose excessively.
  5. Remove the parking brake.
  6. Remove the brake disc flat screws (A).
    Fig 2: Brake Disc Flat Screws With Torque Specification
    G05492122Courtesy of AMERICAN HONDA MOTOR CO., INC.
  7. Remove the brake disc (B) from the hub bearing unit.
    NOTE:
    • If the brake disc is stuck to the hub bearing unit, thread two 8 x 1.25 mm bolts (C) into the brake disc to push it away from the hub bearing unit. Turn each bolt 90 degrees to prevent the brake disc from binding.
    • After installation, check the parking brake, and adjust it necessary (see PEDAL FREE PLAY  ).
  8. Install the brake disc in the reverse order of removal.
    NOTE: Before installing the brake disc, clean the mating surfaces of the hub bearing unit and the inside of the brake disc.
  9. Clean the mating surfaces of the brake disc and the inside of the wheel, then install the rear wheel.
scientia non olet · About LEMON Manuals