LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 2005 >> TSX Automatic >> Repair and Diagnosis (Single Page) >> Restraints >> Air Bag, SRS >> SRS (Supplemental Restraint System) >> Side Impact Sensor (First) Replacement >> Removal

Side Impact Sensor (First) Replacement: Removal

  1. Disconnect the negative cable from the battery, then wait for 3 minutes before starting work.
  2. Disconnect the appropriate side airbag 2P connector (see DISCONNECTING SYSTEM CONNECTORS ).
  3. Remove the seat assembly (see FRONT SEAT REMOVAL/INSTALLATION ).
  4. Remove the front door sill trim (see TRIM REMOVAL/INSTALLATION - DOOR AREAS ) and the B-pillar lower trim panel (see B-PILLAR UPPER/LOWER TRIM ).
  5. Disconnect the floor wire harness 2P connector from the side impact sensor (first).
  6. Using a TORX T30 bit, remove the TORX bolts (A), then remove the side impact sensor (first) (B).
    Fig 1: Identifying Side Impact Sensor And Torx Bolts
    G05489832Courtesy of AMERICAN HONDA MOTOR CO., INC.
scientia non olet · About LEMON Manuals