LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 2005 >> TSX Automatic >> Repair and Diagnosis (Single Page) >> Restraints >> Air Bag, SRS >> SRS (Supplemental Restraint System) >> Side Airbag Replacement >> Installation

Side Airbag Replacement: Installation

NOTE:
  • If the side airbag lid is secured by a tape, remove the tape.
  • Do not open the lid of the side airbag cover.
  • Use a new mounting nut tightened to the specified torque.
  • Make sure that the seat-back cover is installed properly. Improper installation may prevent proper deployment.
  • Be sure to install the harness wires so that they are not pinched or interfering with other parts.
  1. Place the new side airbag on the seat-back frame (A). Tighten the new side airbag mounting nut (B).
    Fig 1: Seat-Back Frame And Side Airbag Mounting Nut w/Torque Specs.
    G05489808Courtesy of AMERICAN HONDA MOTOR CO., INC.
  2. Install the seat-back cover in the reverse order of removal (see FRONT SEAT COVER REPLACEMENT ).
    NOTE: If you are replacing a deployed airbag, replace the reinforcing cloth rear hooks.
  3. Install the seat assembly (see FRONT SEAT REMOVAL/INSTALLATION ), then connect the side airbag harness 2P connector.
  4. Move the front seat and the seat-back through their full ranges of movement, making sure the harness wires are not pinched or interfering with other parts.
  5. Reconnect the negative cable to the battery.
  6. Connect the HDS and clear the DTCs (see CLEAR THE DTC MEMORY WITH THE HDS  ).
  7. After installing the side airbag, confirm proper system operation: Turn the ignition switch ON (II); the SRS indicator should come on for about 6 seconds and then go off.
scientia non olet · About LEMON Manuals