Reopening the SRS Unit Circuit For Diagnosis

Special Tools Required

SRS short canceller 070AZ-SAA0100

NOTE:

To prevent damaging the connector cavity, insert the SRS short canceller straight into the cavity from the terminal side.
Before installing the short canceller, wash it with electrical contact cleaner, then dry it with compressed air.
Do not use the special tool if it is damaged.
Make sure to remove the special tool before reconnecting.

When SRS unit connectors A, B, or C are disconnected, a short circuit is created in the connector by its own function to prevent an airbag deployment. The circuit may need to be opened when diagnosis is done on the system. Insert the short canceller (No. 070AZ-SAA0100) in the specified cavities when it is necessary to keep the circuit open for diagnosis.

Fig 1: Identifying SRS Unit Connectors

Courtesy of AMERICAN HONDA MOTOR CO., INC.

Terminal numbers are shown from the wire side of the female terminals. Insert the short canceller(s) into the cavities on the terminal side of the connector.

Fig 2: Identifying SRS Unit 28P A Connector

Courtesy of AMERICAN HONDA MOTOR CO., INC.

Fig 3: Identifying SRS Unit 28P B Connector

Courtesy of AMERICAN HONDA MOTOR CO., INC.

Fig 4: Identifying SRS Unit 28P C Connector

Courtesy of AMERICAN HONDA MOTOR CO., INC.