Precautions for Electrical Inspections

When using electrical test equipment, insert the probe of the tester into the wire side of the connector. Do not insert the probe of the tester into the terminal side of the connector, and do not tamper with the connector.

Fig 1: Precaution For - Do Not Insert Probe Of Tester Into Terminal Side Of Connector
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Use a U-shaped probe. Do not insert the probe forcibly.

Fig 2: Precaution For - Do Not Insert Probe Forcibly
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Use specified service connectors in troubleshooting. Using improper tools could cause an error in inspection due to poor metal-to-metal contact.