LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 2005 >> TSX Automatic >> Repair and Diagnosis (Single Page) >> Restraints >> Air Bag, SRS >> SRS (Supplemental Restraint System) >> Passenger's Airbag Cutoff Indicator Illumination Bulb Test >> '06-08 models

'06-08 models

  1. Remove the upper panel (see DASHBOARD UPPER PANEL REMOVAL/INSTALLATION ).
  2. Push out the passenger's airbag cutoff indicator (A) from behind the dashboard center vent.
    Fig 1: Identifying Passenger's Airbag Cutoff Indicator And 7P Connector
    G05489846Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Disconnect the 7P connector (B) from the passenger's airbag cutoff indicator.
  4. Check for continuity between the No. 1 and No. 6 terminals of the indicator. If there is no continuity, replace the bulbs (C).
    NOTE: Both illumination bulbs are connected in parallel. If there is continuity, remove the lower hazard switch illumination bulb, and recheck for continuity. If there is no continuity, replace the passenger's airbag cutoff indicator illumination bulb.
  5. Install the parts in the reverse order of removal.
scientia non olet · About LEMON Manuals