Checking Front Passenger's Weight Sensors After a Vehicle Collision ('06-08 Models)

Position the front passenger's seat to the rear most position, adjust the recliner to the forward most position. Do not move it from this position.
Drive the vehicle, accelerate to 20 mph (36 km/h), then stop on level ground.
Make sure the ignition switch is OFF.
Connect the HDS to the data link connector (DLC) (A).

Fig 1: Identifying Data Link Connector
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Turn the ignition switch ON (II).
Make sure the HDS communicates with the vehicle and the SRS unit. If it does not communicate, troubleshoot the DLC circuit:
- '04-06 models (see DLC CIRCUIT TROUBLESHOOTING )
- '07-08 models (see '07-08 MODELS )
From the SRS inspection menu, select Seat Weight Sensor, then Misc test, then "SEAT OUTPUT CHK" and follow the prompts until the front passenger's weight sensor operation check is complete.