LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 2005 >> TSX Automatic >> Repair and Diagnosis (Single Page) >> Restraints >> Air Bag, SRS >> SRS (Supplemental Restraint System) >> Front Impact Sensor Replacement >> Installation

Front Impact Sensor Replacement: Installation

  1. Install the new front impact sensor with new TORX bolts (A), then connect the engine compartment wire harness 2P connector (B) to the front impact sensor (C).

    '04-05 models 

    Fig 1: Identifying Engine Compartment Wire Harness 2P Connector, Front Impact Sensor With Torx Bolts & Spec. (04-05 Models)
    G05489840Courtesy of AMERICAN HONDA MOTOR CO., INC.

    '06-08 models 

    Fig 2: Identifying Engine Compartment Wire Harness 2P Connector, Front Impact Sensor With Torx Bolts & Spec.(06-08 Models)
    G05489841Courtesy of AMERICAN HONDA MOTOR CO., INC.
  2. Reconnect the driver's airbag 4P connector (see DISCONNECTING SYSTEM CONNECTORS ), the front passenger's airbag 4P connector (see DISCONNECTING SYSTEM CONNECTORS ), and both seat belt tensioner 4P connectors (see DISCONNECTING SYSTEM CONNECTORS ).
  3. Reconnect the negative cable to the battery.
  4. Install all removed parts.
  5. After installing the front impact sensor, confirm proper system operation: Turn the ignition switch ON (II); the SRS indicator should come on for about 6 seconds and then go off.
scientia non olet · About LEMON Manuals