LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 2005 >> TSX Automatic >> Repair and Diagnosis (Single Page) >> Restraints >> Air Bag, SRS >> SRS (Supplemental Restraint System) >> Driver's Seat Position Sensor Replacement >> Removal ('06-08 models)

Removal ('06-08 models)

NOTE:
  • Removal of the driver's seat position sensor must be performed according to the precautions/procedures described at the beginning of SRS (see PRECAUTIONS AND PROCEDURES  ).
  • Before disconnecting the driver's seat position sensor 2P connector, disconnect the driver's airbag 4P connector.
  • Do not turn the ignition switch ON (II), and do not connect the battery negative cable while removing the driver's seat position sensor.
  1. Disconnect the negative cable from the battery, then wait for 3 minutes before starting work.
  2. Remove the driver's seat assembly (see FRONT SEAT REMOVAL/INSTALLATION ).
  3. Disconnect the floor wire harness or seat position sensor harness 2P connector (A) from the driver's seat position sensor.
    Fig 1: Identifying Seat Position Sensor Harness 2P Connector And Torx Bolt
    G05489844Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. Remove the TORX bolt (B), then remove the driver's seat position sensor.
scientia non olet · About LEMON Manuals