LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 2005 >> TSX Automatic >> Repair and Diagnosis (Single Page) >> Restraints >> Air Bag, SRS >> SRS (Supplemental Restraint System) >> Driver's Airbag Replacement >> Removal

Driver's Airbag Replacement: Removal

  1. Disconnect the negative cable from the battery, then wait for 3 minutes before starting work.
  2. Remove the access panel (A) from the steering wheel, then disconnect the driver's airbag 4P connector (B) from the cable reel.
    Fig 1: Identifying Driver's Airbag 4P Connector And Access Panel
    G05489788Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Using a TORX T30 bit, remove the two TORX bolts (A).
    Fig 2: Identifying Torx Bolts
    G05489789Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. Disconnect the horn switch connector (1P), then remove the driver's airbag (B).
scientia non olet · About LEMON Manuals