Auto-Tensioner Removal and Installation: Installation

Install the auto-tensioner.

Fig 1: Identifying Auto-Tensioner And Bolts
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Remove the pin or lock pin (P/N 14511-PNA-003) from the auto-tensioner.

Fig 2: Identifying Lock Pin
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Remove old liquid gasket from the chain case cover mating surfaces, bolts, and bolt holes.
Clean and dry the chain case cover mating surfaces.
Apply liquid gasket, P/N 08717-0004,08718-0001, 08718-0003, or 08718-0009, evenly to the chain case mating surface of the chain case cover. Install the component within 5 minutes of applying the liquid gasket.
NOTE:
- If you apply liquid gasket P/N 08718-0012, the component must be installed within 4 minutes.
- If too much time has passed after applying the liquid gasket, remove the old liquid gasket and residue, then reapply new liquid gasket.
  
  Fig 3: Applying Liquid Gasket To Chain Case Mating Surface
  Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install the chain case cover.
NOTE:
- Wait at least 30 minutes before filling the engine with oil.
- Do not run the engine within 3 hours after installing the chain case cover.
  
  Fig 4: Chain Case Cover W/Torque Specification
  Courtesy of AMERICAN HONDA MOTOR CO., INC.