Handling Connectors

Make sure the connectors are clean and have no loose wire terminals.
Make sure multiple cavity connectors are packed with dielectric grease (except watertight connectors).
All connectors have push-down release type locks (A).

Fig 1: Pushing Release Type Locks
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Some connectors have a clip on their side used to attach them to a mount bracket on the body or on another component. This clip has a pull type lock.
Some mounted connectors cannot be disconnected unless you first release the lock and remove the connector from its mount bracket (A).

Fig 2: Removing Connector Of Mount Bracket
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Never try to disconnect connectors by pulling on their wires; pull on the connector halves instead.
Always reinstall plastic covers.

Fig 3: Locating Precaution Of Connectors With Plastic Covers
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Before connecting connectors, make sure the terminals (A) are in place and not bent.

Fig 4: Identifying Connector Terminals
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Check for loose retainer (A) and rubber seals (B).

Fig 5: Identifying Loose Retainer And Rubber Seals
Courtesy of AMERICAN HONDA MOTOR CO., INC.
The backs of some connectors are packed with dielectric grease. Add grease if necessary. If the grease is contaminated, replace it.

Fig 6: Identifying Connector Grease Area Location
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Insert the connector all the way and make sure it is securely locked.
Position wires so that the open end of the cover faces down.

Fig 7: Positioning Wires Cover Faces Down
Courtesy of AMERICAN HONDA MOTOR CO., INC.