LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 2005 >> TSX Automatic >> Repair and Diagnosis (Single Page) >> Electrical >> Body Electrical >> Body Electrical (General Troubleshooting) >> General Troubleshooting Information >> How to Check for DTCs with the Honda Diagnostic System (HDS)

How to Check for DTCs with the Honda Diagnostic System (HDS)

NOTE: For specific operations, refer to the user's manual that came with the Honda Diagnostic System (HDS).
  1. Connect the Honda Diagnostic System (HDS) to the Data Link Connector (DLC) (A) located under the driver's side of the dashboard.
    Fig 1: Connecting HDS To DLC
    G05492744Courtesy of AMERICAN HONDA MOTOR CO., INC.
  2. Turn the ignition switch ON (II).
  3. Make sure the HDS communicates with the vehicle. If it doesn't, troubleshoot the DLC circuit.
  4. Enter BODY ELECTRICAL, then select the test MODE menu.
  5. Check for DTCs with the HDS.
  6. If any DTCs are indicated, note them, and go to the indicated DTC troubleshooting.
scientia non olet · About LEMON Manuals