Rear Door Glass Outer Weatherstrip Replacement

Special Tools Required

KTC trim tool set SOJATP2014 *

* Available through the American Honda Tool and Equipment Program; call 888-424-6857

NOTE:

Once you remove the door glass outer weatherstrip, replace it with a new one because it will bend during removal.
Put on gloves to protect your hands.
Take care not to scratch the door.
Use the appropriate tool from the KTC trim tool set to avoid damage when prying components.

Remove the door panel (see FRONT DOOR WEATHERSTRIP REPLACEMENT ).
Remove the screw (A) from the front edge of the door, and screws (B) fastening the rear portion of the door weatherstrip (C), sash, and the door outer molding (D).

Fig 1: Identifying Front Edge Of Door Screw
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Starting at the front, pull the door glass outer weatherstrip (A) up at each portion where the inner molding (B) catches the inside edge of the window slot. Take care not to bend the door outer molding (C).

Fig 2: Identifying Door Glass Outer Weather Strip
Courtesy of AMERICAN HONDA MOTOR CO., INC.
First slide the door glass outer weatherstrip (A) forward slightly, detach the rear clip (B) by pulling the front of the weatherstrip up, then remove the weatherstrip.

Fig 3: Identifying Door Glass Outer Weatherstrip And Rear Clip
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install a new weatherstrip in the reverse order of removal.