Front Door Glass Outer Weatherstrip Replacement

Special Tools Required

KTC trim tool set SOJATP2014 *

* Available through the American Honda Tool and Equipment Program; call 888-424-6857

NOTE:

Once you remove the door glass outer weatherstrip, replace it with a new one because it will bend during removal.
Put on gloves to protect your hands.
Take care not to scratch the door.
Use the appropriate tool from the KTC trim tool set to avoid damage when prying components.

Remove these items:
- Door panel (see FRONT DOOR PANEL REMOVAL/INSTALLATION )
- Power mirror (see POWER MIRROR REPLACEMENT )
Remove the screw from the rear edge of the door.

Fig 1: Identifying Rear Edge Screw Of Door
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Starting at the rear, pull the door glass outer weatherstrip (A) up at each portion where the inner molding (B) catches the inside edge of the window slot, then remove the weatherstrip.

Fig 2: Identifying Door Glass Outer Weatherstrip
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install a new weatherstrip in the reverse order of removal.