Vanity Mirror Light Test

Open the sunvisor.
Remove the sunvisor (see HEADLINER REMOVAL/INSTALLATION ).
Disconnect the 2P connector (A) from the vanity mirror light.
Vanity mirror light: 2 W

Fig 1: Identifying Vanity Mirror Light 2P Connector Terminal
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Check for continuity between the No. 1 and No. 2 terminals.
- With the vanity mirror cover (B) opened, there should be continuity.
- With the vanity mirror cover closed, there should be no continuity.
If the continuity is not as specified, replace the bulb (C) or the sunvisor.