LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 2005 >> TSX Automatic >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Interior/Exterior Trim >> Exterior Trim >> Hood Molding Replacement >> '04-05 Models

'04-05 Models

  1. Remove the nuts (A), and detach the clip (B) by pushing it from the drain hole (C) in the hood, then remove the hood molding (D). Take care not to scratch the hood.
    Fig 1: Removing Hood Molding w/Torque Specification
    G05492534Courtesy of AMERICAN HONDA MOTOR CO., INC.
  2. Install the molding in the reverse order of removal, and check if the clip is damaged or stress-whitened, and if necessary, replace it with a new one.
scientia non olet · About LEMON Manuals