LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 2005 >> TSX Automatic >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Exterior Lights >> Turn Signal/Hazard Warning Lights >> Hazard Warning Switch Test/Replacement >> '06-08 models

'06-08 models

  1. Remove the upper panel (see DASHBOARD UPPER PANEL REMOVAL/INSTALLATION ).
  2. Push out the hazard warning switch (A) from behind the upper panel.
    Fig 1: Identifying Hazard Warning Switch 7P Connector Terminals
    G05492887Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Disconnect the 7P connector (B) from the hazard warning switch.
  4. Check for continuity between the terminals in each switch position.
    Fig 2: Checking For Continuity Between Terminals In Each Switch Position
    G05492888Courtesy of AMERICAN HONDA MOTOR CO., INC.
  5. If the continuity is not as specified, replace the bulb (C) or the hazard warning switch.
scientia non olet · About LEMON Manuals