LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 2005 >> TSX Automatic >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Exterior Lights >> Exterior Lights >> Brake Pedal Position Switch Test

Brake Pedal Position Switch Test

  1. Disconnect the 4P connector (A) from the brake pedal position switch (B).
    Fig 1: Identifying Brake Pedal Position Switch 4P Connector Terminal
    G05492873Courtesy of AMERICAN HONDA MOTOR CO., INC.
  2. Check for continuity between the No. 1 and No. 2 terminals.
    • There should be continuity when the brake pedal is pressed.
    • There should be no continuity when the brake pedal is released.
  3. Check for continuity between the No. 3 and No. 4 terminals.
    • There should be no continuity when the brake pedal is pressed.
    • There should be continuity when the brake pedal is released.
  4. If necessary, adjust or replace the switch, or adjust the pedal height (see BRAKE PEDAL AND BRAKE PEDAL POSITION SWITCH ADJUSTMENT ).
scientia non olet · About LEMON Manuals