The MID displays an HFL message that does not go away after pressing the HFL BACK button
- Connect the HDS to the DLC.
- Turn the ignition switch ON (II).
- Clear the DTCs with the HDS.
- Turn the ignition switch to LOCK (0), and then ON (II).
- Check for DTCs with the HDS.
Are there any DTCs indicated?
YES - Repair the indicated DTCs and recheck.
NO - Go to step 6.
- Turn the ignition switch to LOCK (0).
- Substitute a known-good Hands Freelink control unit.
- Turn the ignition switch ON (II).
- Check the MID display.
Are the messages cleared?
YES - Replace the original Hands Freelink control unit (see CONTROL UNIT INPUT TEST/REPLACEMENT ).
NO - Replace the gauge control module (see GAUGE CONTROL MODULE REPLACEMENT ).