Select/Reset/Information Switch Test/Replacement

('06-08 models) 

1. Remove the driver's airbag assembly (see DRIVER'S AIRBAG REPLACEMENT ).
2. Disconnect the 8P connector (A).
   Fig 1: Identifying 8P Connector Terminal

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
3. Remove the two screws and the select/reset/ information switch (B).
4. Check for continuity between the terminal in each switch position according to Fig 2.
   Fig 2: Checking For Continuity Between Terminal In Each Switch Position

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
5. If the continuity is not as specified, replace the switch.