Brake Pads: Remove & Replace
WARNING: This page is about the NSX 3.0 NA1, which is a different variant/trim than selected.
Includes: Clean, lube and/or replace Brake Hardware as necessary. Adjust Brakes (where applicable).
Includes: Repack Wheel Bearings (where applicable).
DOES NOT include refinishing.| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| All,Both Axles | 1.8 | B | ||
| Front,Both Sides | 1.0 | B | ||
| Rear,Both Sides | 1.0 | B | ||
| Combination Procedure: BRAKE HOSE: Replace: | ||||
| Each Additional | Includes: Bleed Brakes. | 0.2 | B | |
| One | Includes: Bleed Brakes. | 0.6 | B | |
| Combination Procedure: CALIPER: Overhaul: | ||||
| One | Includes: Bleed Brakes. | 0.6 | B | |
| Combination Procedure: CALIPER: Replace: | ||||
| One | Includes: Bleed Brakes. | 0.4 | B | |
| Combination Procedure: DISC ROTOR: Remove and Install for Refinishing: This operation does not apply to drive axles. If on vehicle refinishing is not possible use appropriate repair operation. | ||||
| Rear | 0.2 | B | ||
| Combination Procedure: WHEEL BEARING: Replace: | ||||
| Front,Each | 0.7 | B | ||
| Rear,Each | 0.2 | B | ||