Ignition Switch Test: 3.5RL
Disconnect negative battery cable. Remove lower instrument panel cover and driver-side knee bolster. Disconnect 7-pin connector from steering column harness. With ignition switch in appropriate position, check continuity between specified connector terminals. See Fig 1. See IGNITION SWITCH CONTINUITY table. If continuity is not as specified, replace ignition switch.
IGNITION SWITCH CONTINUITY
| Ignition Switch Position | Check for Continuity Between Terminals No. |
|---|---|
| LOCK | No Continuity |
| ACC | 1 & 6 |
| ON | 1, 3, 6 & 7 |
| START | 1, 3 & 4 |