LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 2001 >> 3.2CL Base >> Repair and Diagnosis (Single Page) >> Heating, Ventilation & A/C (HVAC) >> General Servicing >> Air Conditioning Compressor Servicing >> HARRISON (DELPHI Thermal) V7 7-Cylinder >> Shaft Seal >> Installation

Shaft Seal: Installation

  1. Install Shaft Seal Protector (J-34614) over compressor shaft. With shaft seal protector in place, lubricate shaft seal with refrigerant oil and install on to Shaft Seal Remover/Installer (J-34614).
  2. Push shaft seal into compressor using a rotary motion until seal bottoms. Install new snap ring with flat side against seal. Install clutch plate and hub assembly onto compressor shaft. See CLUTCH COIL & BEARING ASSEMBLY .
scientia non olet · About LEMON Manuals