LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 2001 >> 3.2CL Base >> Repair and Diagnosis (Single Page) >> Heating, Ventilation & A/C (HVAC) >> General Servicing >> Air Conditioning Compressor Servicing >> HALLA HS-15 & HALLA HS-18 >> Shaft Seal >> Removal

Shaft Seal: Removal

  1. Hold clutch plate stationary and remove clutch hub retaining bolt. Remove clutch hub, using an 8 mm threaded into shaft hole. Remove shaft seal felt from nose of compressor.
  2. Thoroughly clean seal area of compressor using low-pressure compressed air and a lint-free cloth. Remove compressor shaft seal internal snap ring using Remover (09977-33800). Position Shaft Seal Remover (09977-33700) over compressor shaft.
  3. Push shaft seal remover downward against seal. Ensure end of shaft seal remover is engaged with inside of seal. Hold hex part of seal remover and rotate shaft seal remover handle clockwise to expand remover tip inside seal. Pull shaft seal from compressor.
scientia non olet · About LEMON Manuals