LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 2001 >> 3.2CL Base >> Repair and Diagnosis (Single Page) >> Engine Performance >> Remove, Overhaul & Install >> Engine Controls - Removal, Overhaul & Installation >> Ignition System >> Crankshaft Position (CKP), Crankshaft Speed Fluctuation (CKF) Cylinder Position (CYP) & Top Dead Center (TDC) Sensors >> Removal & Installation (Integra)

Removal & Installation (Integra)

  1. TDC/CKP/CYP sensors are an integral component of distributor. Distributor housing must be replaced if TDC, CKP and/or CYP sensors are faulty. See DISTRIBUTOR . CKF sensor is located behind drive belt. Remove wheel well splash shield. Remove accessory drive belts.
  2. Remove valve cover. Remove crankshaft pulley. Remove timing belt middle and lower covers. DO NOT use middle and lower covers to store removed items. Disconnect CKF sensor connector, then remove sensor. To install, reverse removal procedure. Clean middle cover and lower cover. See appropriate article in ENGINES for timing belt installation procedure.
scientia non olet · About LEMON Manuals