LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 1999 >> SLX >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Symptom Tests >> Oil Pressure Gauge Reading Is Too Low >> Models Without Traction On Demand (TOD) Indicator

Models Without Traction On Demand (TOD) Indicator

  1. If low oil pressure indicator is also on with engine running, check for possible mechanical failure. If low oil pressure indicator is not on, go to next step.
  2. Disconnect oil pressure sending unit. Turn ignition switch to ON position. Connect a fused jumper wire between ground and oil pressure sending unit (Yellow/Green wire). See WIRING DIAGRAMS  . If oil pressure gauge reading varies, replace oil pressure sending unit. If oil pressure gauge readings do not vary, go to next step.
  3. Disconnect instrument panel connector I-10. Connect a fused jumper wire between ground and instrument panel connector I-10 cavity terminal No. 19. See Figure . If oil pressure gauge reading varies, go to next step. If oil pressure gauge readings do not vary, replace instrument cluster. See INSTRUMENT CLUSTER  under REMOVAL & INSTALLATION.
  4. Repair open in sending unit circuit (Yellow/Green wire at sending unit; Yellow/Black wire at instrument panel). See WIRING DIAGRAMS  . Recheck system operation.
scientia non olet · About LEMON Manuals