Hazard Warning Switch Test

Remove hazard warning switch. Check for continuity between specified switch terminals with switch in ON and OFF position. See HAZARD WARNING SWITCH CONTINUITY table. See Fig 1 or Fig 2 . If continuity is not as specified, replace hazard warning switch. If continuity is as specified, check turn signal/hazard relay input. See TURN SIGNAL/HAZARD RELAY INPUT TEST under SYSTEM TESTS.

HAZARD WARNING SWITCH CONTINUITY

Switch Position		Continuity Between Terminals No.
Off
3.2TL		5 & 10; 6 & 7
3.5RL		1 & 5
On
3.2TL		1, 2 & 3; 5 & 9; 6 & 7
3.5RL		1 & 5; 3 & 2; 3 & 4

Fig 1: Identifying Hazard Warning Switch Terminals (3.2TL)

Courtesy of AMERICAN HONDA MOTOR CO., INC.

Fig 2: Identifying Hazard Warning Switch Terminals (3.5RL)

Courtesy of AMERICAN HONDA MOTOR CO., INC.