Hazard Warning Switch Test

Check for continuity between specified switch terminals with switch in ON and OFF position. See Fig 1 or Fig 2 . If continuity is not as specified, replace hazard warning switch. If continuity is as specified, check turn signal/hazard relay input. See TURN SIGNAL/HAZARD RELAY INPUT TEST  under SYSTEM TESTS.

Fig 1: Testing Hazard Warning Switch (2.5TL & 3.2TL)

Courtesy of AMERICAN HONDA MOTOR CO., INC.

Fig 2: Testing Hazard Warning Switch (3.5RL)

Courtesy of AMERICAN HONDA MOTOR CO., INC.