LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 1997 >> 3.5RL >> Repair and Diagnosis >> External Pages >> Different car >> Section 3 (Automatic Transmission Diagnosis - BAXA, B6VA & MDWA) >> Self-Diagnostic System >> "D4" Indicator Light Circuit Check >> "D4" Indicator Light Remains On Constantly - Not Flashing (2.3CL & Odyssey)

"D4" Indicator Light Remains On Constantly - Not Flashing (2.3CL & Odyssey)

WARNING: This page is about a different car, the 1998 Honda Odyssey, 1998 Honda Accord, and 1998 Acura 2.3CL. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn ignition off. Disconnect 32-pin PCM harness connector "A". Turn ignition on. Using a DVOM, measure voltage between ground and 32-pin PCM harness connector "A", terminal No. 14 (Blue/Red wire). If no voltage is present, go to next step. If voltage is present, repair Blue/Red wire for a short to power.
  2. Turn ignition off. Reconnect PCM harness connector. Turn ignition on. Shift to any position except "D4". Measure voltage (backprobe) between ground and 16-pin PCM harness connector "D", terminal No. 9 (Light Green/Black wire). If voltage is present, replace PCM. If no voltage is present, check Light Green/Black wire for a short to ground. Repair as necessary. If no problem is found, replace A/T gear position indicator.
scientia non olet · About LEMON Manuals