LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 1997 >> 3.5RL >> Repair and Diagnosis >> External Pages >> Different car >> Section 3 (Automatic Transmission Diagnosis - BAXA, B6VA & MDWA) >> Removal & Installation >> 2ND Clutch Pressure Switch >> Removal & Installation

Removal & Installation

WARNING: This page is about a different car, the 1998 Honda Odyssey, 1998 Honda Accord, and 1998 Acura 2.3CL. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect harness connector from 2nd clutch pressure switch, located on top of transaxle. See Figure .
  2. Remove switch and sealing washer. To install, reverse removal procedure. Install switch to 15 ft. lbs (20 N.m).
scientia non olet · About LEMON Manuals