LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 1995 >> NSX Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 8 (Wiper System & Washer System) >> Trouble Shooting >> Preliminary Inspection

Preliminary Inspection

WARNING: This page does not describe the selected car, but rather 16 other vehicles, including the 2005 Acura NSX, 2004 Acura NSX, 2003 Acura NSX-T, 2003 Acura NSX, and 2002 Acura NSX-T. However, it is still accessible from the selected car via links, so may be relevant.

Verify customer complaint by operating suspected system. Visually inspect for obvious signs of mechanical and electrical damage. Inspect for blown fuses and damaged relays. Inspect for loose or corroded connections, damaged wiring harnesses and/or switches. See Fig 1 . Check for a broken or partially broken wire inside insulation, which could cause system malfunction but prove good in a continuity/voltage check with system disconnected. Ensure any aftermarket electronic equipment is properly installed. If fault is found, repair as necessary. If no fault is found, repair by symptom.

Fig 1: Trouble Shooting Wiper/Washer System
G00088125Courtesy of AMERICAN HONDA MOTOR CO., INC.