Bleeding Brake System
CAUTION:
Use only clean DOT 3 or 4 brake fluid. Ensure no dirt or other foreign matter contaminates brake fluid. DO NOT mix different brands of brake fluid, as they may not be compatible. Avoid spilling brake fluid on car, as it will damage paint. If brake fluid contacts paint, immediately flush with water.
NOTE:
The reservoir on the master cylinder must be full at the start of bleeding procedure, and checked after bleeding each brake caliper. Add fluid as required.
- Have an assistant slowly pump brake pedal several times then apply steady pressure. Loosen brake bleed screw to allow air to escape from system. See BRAKELINE BLEEDING SEQUENCE table.
- Tighten bleed screw to specification. See TORQUE SPECIFICATIONS . Repeat procedure until air bubbles no longer appear in fluid. Bleed brakes in following sequence: right rear, left front, left rear, right front. Road test vehicle and check brake performance.