LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 1993 >> Integra GS-R >> Repair and Diagnosis (Single Page) >> Heating, Ventilation & A/C (HVAC) >> General Servicing >> A/C Compressor Servicing >> SANDEN Scroll Clutch Coil And Shaft Seal R & I >> Removal (CHRYSLER & MITSUBISHI GALANT & Mirage)

Removal (CHRYSLER & MITSUBISHI GALANT & Mirage)

  1. Hold clutch plate by securing 2 box-end wrenches with two 6-mm bolts, 1" (25 mm) or longer. Holding bow-end wrenches, use a ratchet and socket to remove clutch hub nut.
  2. Remove clutch plate. See Figure. Remove snap ring with internal snap ring pliers. Remove clutch hub. Remove snap ring and clutch coil.
  3. Remove front housing bolts. Remove front housing and "O" ring from compressor. Remove shaft seal from shaft. Remove snap ring from back side of front housing. Remove seal plate. Use brass drift and hammer to lightly tap shaft bearing from front housing. Remove felt seal.
NOTE: DO NOT touch sealing surfaces of shaft seal carbon ring and shaft seal plate.
scientia non olet · About LEMON Manuals