LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 1993 >> Integra GS-R >> Repair and Diagnosis (Single Page) >> Heating, Ventilation & A/C (HVAC) >> General Servicing >> A/C Compressor Servicing >> SANDEN Scroll Clutch Coil And Shaft Seal R & I >> Installation (CHRYSLER & MITSUBISHI Except GALANT & Mirage)

Installation (CHRYSLER & MITSUBISHI Except GALANT & Mirage)

  1. To install shaft seal, ensure front housing is free of foreign objects. Lubricate Shaft Seal Protector (MB991459) and place over compressor shaft. Lubricate shaft seal and install using shaft seal remover/installer. Remove shaft seal protector.
  2. Using a 21 mm socket or Drift (MB991301), carefully press bearing onto compressor shaft. Install clutch coil so that alignment pin is engaged. Install clutch coil snap ring with tapered side facing out.
  3. Align armature plate with crankshaft spline. Tighten shaft nut to 12 ft. lbs (16 N.m). Using feeler gauge, ensure clearance between pressure plate and pulley is .016-.024" (.40-0.60 mm). If clearance is incorrect, add or remove shim(s) as necessary.
Fig 1: Exploded View Of Compressor (Sanden Scroll)
G94A10066Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals