LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 1992 >> Integra GS-R >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Mechanical >> 1.7L 4-CYL >> Removal & Installation >> Rear Crankshaft Oil Seal >> Removal

Rear Crankshaft Oil Seal: Removal

  1. Disconnect negative battery cable. Remove transaxle assembly. See appropriate CLUTCH article in CLUTCHES section or TRANSMISSION REMOVAL & INSTALLATION - A/T article in AUTOMATIC TRANS SERVICE section.
  2. Place reference mark on clutch pressure plate (M/T models) and flywheel for reassembly reference. Remove pressure plate and clutch disc (if equipped). Remove flywheel. Pry seal from cover.
NOTE: When installing new crankshaft oil seal, align hole in Driver Attachment (07948-SB00101) with pin on crankshaft.
scientia non olet · About LEMON Manuals