Installation

AUDIO / VIDEO: STEERING PAD SWITCH: INSTALLATION

1. INSTALL STEERING PAD SWITCH LH

(a) Engage the 2 pins and claw to install the steering pad switch LH.

(b) Install the screw.

Torque : 2.4 Nm (24 kgf-cm, 21 in-lbf)

(c) Connect the connector to the spiral cable.

2. INSTALL STEERING PAD SWITCH ASSEMBLY

(a) Engage the 2 pins and claw to install the steering pad switch assembly.

(b) Install the screw.

Torque : 2.4 Nm (24 kgf-cm, 21 in-lbf)

(c) Engage the 2 pins and claw to install the steering pad switch.

(d) Install the screw.

Torque : 2.4 Nm (24 kgf-cm, 21 in-lbf)

(e) Connect the connector to the spiral cable.

3. INSTALL STEERING PAD Installation

4. INSTALL LOWER NO. 3 STEERING WHEEL COVER Installation

5. INSTALL LOWER NO. 2 STEERING WHEEL COVER Installation

6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

7. INSPECT STEERING PAD Installation

8. INSPECT SRS WARNING LIGHT

Diagnosis System