Installation

2AZ-FE COOLING: THERMOSTAT: INSTALLATION

1. INSTALL THERMOSTAT

(a) Install a new gasket onto the thermostat.

(b) Install the thermostat with the jiggle valve upward.





HINT
The jiggle valve may be set to within 10° on either side of the indicated position.

2. INSTALL WATER INLET

(a) Install the water inlet with the 2 nuts.





Torque : 9.0 Nm (92 kgf-cm, 80 in-lbf)

3. CONNECT NO. 2 RADIATOR HOSE Installation

4. ADD ENGINE COOLANT Service and Repair

5. INSPECT FOR COOLANT LEAK Testing and Inspection