Clearing Trouble Codes

NOTE: This is the only information provided by the manufacturer for Clearing Diagnostic Trouble Codes for this system.

Without TOYOTA hand-held tester




Clear the DTC.

1. Using SST connect terminals Tc and CG of DLC3.
SST 09843-18040

2. Turn the ignition switch ON.
3. Clear the DTC stored in ECU by depressing the brake pedal 8 or more times within 5 seconds.
4. Check that the warning light shows the normal code.
5. Remove the SST from the terminals of DLC3.
SST 09843-18040

With TOYOTA hand-held tester




Clear the DTC.

1. Hook up the TOYOTA hand-held tester to the DLC3.
2. Turn the ignition switch ON.
3. Operate the TOYOTA hand-held tester to erase code (See TOYOTA hand-held tester operator's manual.).