Symptoms - Antilock Brake System

Symptoms - Antilock Brake System

Important: The following steps must be completed before using the symptom tables.

1. Perform the Diagnostic System Check - Vehicle, before using the symptom tables in order to verify that all of the following are true: Initial Inspection and Diagnostic Overview

* There are no DTCs set.

* The control module(s) can communicate via the serial data link.

2. Review the system operation in order to familiarize yourself with the system functions. Refer to ABS Description and Operation.

Visual/Physical Inspection

* Inspect for aftermarket devices which could affect the operation of the antilock brake system ABS). Refer to Checking Aftermarket Accessories in Diagnostic Aids. Component Tests and General Diagnostics
* Inspect the easily accessible or visible system components for obvious damage or conditions which could cause the symptom.
* Inspect the master cylinder reservoir for the proper fluid level.

Intermittent

Faulty electrical connections or wiring may be the cause of intermittent conditions. Refer to Testing for Intermittent Conditions and Poor Connections in Diagnostic Aids. Component Tests and General Diagnostics

Symptom List

Refer to a symptom diagnostic procedure from the following list in order to diagnose the symptom:

* ABS Active Indicator Always On
* ABS Active Indicator Inoperative
* Traction Control Indicator Always On
* Traction Control Indicator Inoperative