Torque Converter Cover: Service and Repair

Torque Converter Cover Replacement

Removal Procedure





1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (Service and Repair) .
2. Remove the torque converter cover bolts.
3. Remove the torque converter covers.



Installation Procedure






Important: If equipped with 5.3L V8-The tab must be on the engine side of the engine oil pan bolt.


1. Install the torque converter covers.

Notice: Refer to Fastener Notice (Fastener Notice) .

2. Install the torque converter cover bolts.

Tighten the bolts to 10 N.m (89 lb in).

3. Lower the vehicle.