Canister Vent Valve: Service and Repair

Evaporative Emission Canister Vent Solenoid Valve Replacement

Removal Procedure





1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (Service and Repair) .
2. Disconnect the evaporative emission (EVAP) vent valve electrical connector (1).
3. Remove the EVAP vent valve bracket bolt (3).
4. Remove the vent hose (4) from the EVAP vent valve.
5. Remove the EVAP vent valve from the bracket (2).



Installation Procedure





1. Install the EVAP vent valve to the bracket (2).
2. Install the vent hose (4) to the EVAP vent valve.
3. Install the EVAP vent valve and the bracket.

Notice: Refer to Fastener Notice (Fastener Notice) .

4. Install the EVAP vent valve bracket bolt (3).

Tighten the bolt to 10 N.m (89 lb in).

5. Connect the EVAP vent valve electrical connector (1).
6. Lower the vehicle.