Hood Rear Outer Seal Replacement

Hood Rear Outer Seal Replacement

Removal Procedure




1. Open the hood.
2. Pull the rear side hood seal from the pinch-weld flange and motor compartment flange.
3. Remove the rear side hood seal from the vehicle.
4. Clean any adhesive from the pinch-weld flange and motor compartment flange surface.

Installation Procedure




1. Remove the protective backing paper from the adhesive on the rear side hood seal.
2. Install the rear side hood seal to the pinch-weld flange and motor compartment flange.
3. Press the side rear hood seal onto the pinch-weld flange and motor compartment flange until the adhesive is fully adhered.
4. Close the hood.