Rear Seat Cushion Outer Trim Panel Replacement (Bucket)

Rear Seat Cushion Outer Trim Panel Replacement (Bucket)

Removal Procedure

1. Remove the rear bucket seat from the vehicle. Refer to Rear Bucket Seat Replacement (Rear Bucket Seat Replacement).




2. Remove the rear screw from the rear seat cushion trim cover.




3. Remove the rear seat recliner handle.
4. Remove the rear seat cushion trim cover from the rear seat.

Installation Procedure

1. Position the rear seat cushion trim cover from the rear seat.




2. Install the upper retainer clip to the seat frame, pressing into place until fully seated.





Notice: Refer to Fastener Notice .

3. Install the rear screw to the seat cushion trim cover.

Tighten the rear seat cushion trim cover screw to 2 Nm (18 lb in).




4. Install the rear seat recliner handle.
5. Install the rear bucket seat to the vehicle. Refer to Rear Bucket Seat Replacement (Rear Bucket Seat Replacement).