Windshield Pillar Garnish Molding Replacement

Windshield Pillar Garnish Molding Replacement

Removal Procedure




1. Remove the windshield garnish molding from the windshield pillar by pulling the windshield garnish molding to release the push-in retainers.
2. Remove the windshield garnish molding from the windshield pillar.

Installation Procedure




1. Align the windshield garnish molding to the trough on the upper instrument panel trim panel.
2. Align the windshield garnish molding to the retainers slots in the windshield pillar.
3. Install the windshield garnish molding, applying pressure at all the retainer locations until fully seated.