Rear Floor Carpet Trim Plate Replacement

Rear Floor Carpet Trim Plate Replacement

Removal Procedure

1. Remove the rear seats. Refer to the following procedures:

* Rear Bucket Seat Replacement (Rear Bucket Seat Replacement)
* Rear 50-50 Split Seat Replacement (Rear 50-50 Split Seat Replacement)




2. Release the T-pin retainer in the anchor plate bezel using a small flat-bladed tool.




3. Remove the anchor plate bezel from the floor.

Installation Procedure




1. Position the anchor plate bezel to the floor.




2. Install the T-pin on the anchor plate using a small flat-bladed tool, pressing into place until fully seated.
3. Install the rear seats. Refer to the following procedures:

* Rear Bucket Seat Replacement (Rear Bucket Seat Replacement)
* Rear 50-50 Split Seat Replacement (Rear 50-50 Split Seat Replacement)