Parking Assist Distance Sensor: Service and Repair

Active Park Assist Sensor

NOTE: LH side shown, RH side similar.











Removal

1. Remove the fender splash shield screws and lower bolts.

2. Position the fender splash shield aside and disconnect the electrical connector.

3. With a suitable tool (such as a flat-blade screwdriver) gently pry the retaining tabs to remove the active park assist sensor(s).
- Remove the active park assist sensor(s) from the front bumper cover.

4. To install, reverse the removal procedure.

5. After installing the sensor(s), use the scan tool to verify that the active park assist sensor PIDs responding correctly. Carry out the Azimuth System Check Active Park Assist. If the active park assist sensor does not respond correctly, refer to Active Park Assist. Active Park Assist