Clutch Pedal Position Sensor / Switch: Service and Repair

CLUTCH PEDAL POSITION SWITCH REMOVAL/INSTALLATION [G66M-R]

1. Disconnect the negative battery cable.

2. Disconnect the clutch pedal position switch connector.

3. Remove the clutch pedal position switch from the pedal bracket.






4. Insert a new clutch pedal position switch into the pedal bracket hole until the switch stops.

5. Rotate the clutch pedal position switch 45° clockwise.






6. Verify that the clutch pedal position switch is locked securely.

7. Install in the reverse order of removal.