Selector Lever Component Inspection

SELECTOR LEVER COMPONENT INSPECTION

CAUTION:
- Water or foreign objects entering the connector can cause a poor connection or corrosion. Be sure not to drop water or foreign objects on the connector when disconnecting it.
- Do not damage the terminals.

1. Disconnect the selector lever component connector.
a. Disconnect the negative battery cable.

b. Remove the rear console. (See Rear Console Removal/Installation.)

c. Disconnect the selector lever component connector.






2. Verify that the continuity is as indicated in the table.











- If there is any malfunction, replace the selector lever component. Service and Repair